DGCA Technical General: Gas Turbines — Systems & Operation Questions
146 exam-style Gas Turbines — Systems & Operation questions for the DGCA Technical Generalpaper (CPL & ATPL). The first 12 are free below with answers and explanations — sign up free to practise all of them with progress tracking.
- Q1
A centrifugal breather is used on a gas turbine engine:
- ATo circulate the oil smoothly.
- BTo minimise oil loss.
- CTo emulsify the oil and air mixture for greater viscosity.
- DTo allow oxidisation of the oil.
Show answer
Correct answer: B. To minimise oil loss.
This Explanation is Coming Soon
- Q2
What is the effect on EGT and EPR if a bleed valve is opened?
- A Increase, increase
- B Decrease, decrease
- C Decrease, increase
- D Increase, decrease
Show answer
Correct answer: D. Increase, decrease
Opening a bleed valve extracts compressed air, so less mass flow passes through the turbine and the engine pressure ratio falls; to maintain thrust the fuel system holds or increases fuel flow into the reduced airflow, raising the exhaust gas temperature. The result is EGT up, EPR down.
- Q3
Where is torque measured in a turboprop engine
- A Accessory gearbox
- B Reduction gearbox
- C At the turbine
- D At the constant speed unit oil pump
Show answer
Correct answer: B. Reduction gearbox
Turboprop torque is measured at the reduction gearbox, where a torquemeter senses the reaction of the gear train, typically as oil pressure proportional to the torque being transmitted to the propeller. This is the point where the drive to the propeller can be directly sensed.
- Q4
A relight is :
- AThe initiation of the after burning system.
- BWhat occurs when the engine drain valve is stuck.
- CThe action of the restarting a flamed out engine usually while airborne.
- Dmid air engine restart
Show answer
Correct answer: C. The action of the restarting a flamed out engine usually while airborne.
A relight is the restarting of an engine that has flamed out, normally carried out while airborne within the engine's relight envelope of speed and altitude. Ignition is reintroduced with fuel flowing, using windmilling rpm or starter assistance to sustain rotation until combustion is re-established.
- Q5
EPR is a
- ARatio between ambient pressure and exhaust pressure.
- BRatio between ambient pressure and fan pressure.
- CRatio between intake pressure and compressor delivery pressure.
- DRatio between exhaust pressure and intake pressure.
Show answer
Correct answer: D. Ratio between exhaust pressure and intake pressure.
This Explanation is Coming Soon
- Q6
What is engine pressure ratio?
- AThe ratio of turbine outlet pressure to compressor inlet pressure
- B The ratio of turbine inlet pressure to compressor inlet pressure
- CTurbine outlet pressure x compressor outlet pressure
- D Compressor inlet pressure divided by turbine outlet pressure
Show answer
Correct answer: A. The ratio of turbine outlet pressure to compressor inlet pressure
Engine pressure ratio (EPR) is the ratio of the turbine (jet-pipe) outlet total pressure to the compressor inlet total pressure. It is used as a direct measure of the thrust being produced by the engine.
- Q7
The term "Self Sustaining Speed" means that:
- A The speed from which the engine can accelerate to full power within 5 seconds
- BThe engine will run independently of external help
- CThe speed from which the engine can accelerate to idle without the help of the starter motor.
Show answer
Correct answer: C. The speed from which the engine can accelerate to idle without the help of the starter motor.
Self-sustaining speed is the rpm from which a gas turbine can accelerate to idle without further help from the starter motor, because the turbine is by then extracting enough energy to drive the compressor and continue accelerating unaided. Below this speed, cutting the starter would cause the engine to hang or hot start.
- Q8
343.In a High Energy Igniter Unit, the choke:
- AProtects the unit from excessive voltages.
- BProlongs the discharge to the plug
- C Protects the unit from excessive current.
Show answer
Correct answer: B. Prolongs the discharge to the plug
In a high-energy ignition unit the choke is an inductor that opposes the rapid collapse of current, so it extends the duration of the spark discharge at the igniter plug, giving the fuel/air mixture more time to light.
- Q9
When after burning the jet pipe will:
- AClose to allow for the decreased volume of gas.
- BOpen to allow for the increased volume of gas.
- CRemain the same
- DRemain the same until the temperature reaches 1700C then open.
Show answer
Correct answer: B. Open to allow for the increased volume of gas.
This Explanation is Coming Soon
- Q10
A re-light envelope:
- AShows the flame stability limits.
- BShows airspeed and altitude ilmitations for an in-flight restart.
- C Shows fuel/air mixture limitations for an in-flight restart
Show answer
Correct answer: B. Shows airspeed and altitude ilmitations for an in-flight restart.
The relight envelope defines the combinations of airspeed and altitude within which an in-flight restart can be expected to succeed, because windmilling RPM and combustion conditions deteriorate at high altitude and low airspeed.
- Q11
Use of reverse thrust below the recommended speed may cause:
- AOver stressing of the gear oleos.
- BIngestion of the exhaust gases and foreign objects.
- CMore fuel to be provided to the burners.
- DThe T.G.T. limit to be exceeded, in which case the reverse thrust lever will return to the forward thrust position.
Show answer
Correct answer: B. Ingestion of the exhaust gases and foreign objects.
This Explanation is Coming Soon
- Q12
How do you control power in a jet engine
- A By controlling the mixture ratio
- B By controlling the fuel flow
- C By controlling the airflow
- D By controlling the bleed valves
Show answer
Correct answer: A. By controlling the mixture ratio
Thrust in a gas-turbine engine is set solely by regulating the fuel flow to the combustion chambers; moving the thrust lever schedules more or less fuel, which changes the gas energy and hence the engine speed and thrust.
134 more Gas Turbines — Systems & Operation questions in the full bank
Create a free account to practise every Gas Turbines — Systems & Operation question with instant scoring, chapter tests, previous DGCA papers and full-length mock exams.
Start practising free